- Celal Bayar Üniversitesi Fen Bilimleri Dergisi
- Vol: 17 Issue: 1
- Static Analysis of the Slotted Upper Plate of Low Pressure Casting Machine
Static Analysis of the Slotted Upper Plate of Low Pressure Casting Machine
Authors : Yasemin Nur Aydin, Onur Ozaydin, Ahmet Alper Akiş
Pages : 35-41
Doi:10.18466/cbayarfbe.779687
View : 27 | Download : 7
Publication Date : 2020-12-30
Article Type : Research
Abstract :In this study, the process improvement / Kaizen case study of a casting mold set-up process taking an average of 20 minutes, is examined. The aim of this work is reducing the set-up time and improving ergonomic conditions. Since existing operating conditions cause a waste of time and result in non-ergonomic conditions, an air impact wrench had to be used in the mold assembly process. To be able to use the air impact wrench a new geometry had to implemented on casting mold and this design change was analyzed in ANSYS software to avoid a failure in working conditions. It was concluded that the maximum stress on the mold is not at a level where it will cause failure. After the initial geometry improvement process, a further ANSYS-Topology optimization process is conducted to reduce weight of the mold. As a result of this the set-up time decreased to an average of 9 minutes. Consequently, big benefits in terms of cycle time, occupational health and safety, improvement in the process and cost have been achieved.Keywords : ANSYS Static Structural, ANSYS Topology Optimization, Case Study, Kaizen, Process Improvement