- Celal Bayar Üniversitesi Fen Bilimleri Dergisi
- Vol: 16 Issue: 2
- Compare Between the Results of the Casting Simulation and the Results of Experimental Production wit...
Compare Between the Results of the Casting Simulation and the Results of Experimental Production with Calculating the Interface Heat Transfer Coefficient of the Casting-Mold
Authors : Murat Can Nişanci, Ali Yurddaş
Pages : 169-181
View : 24 | Download : 9
Publication Date : 2020-06-24
Article Type : Research
Abstract :Sanitary tapware that can drain hot and cold water from the plumbing systems in the desired proportions by mixing are called faucet. The production of faucets used today is conducted by using a low-pressure casting method. The raw material of the body, which is the main part of faucets, is generally brass alloy (CuZn39Pb1Al-C). The material of faucet molds produced using the casting method is the copper-beryllium alloy (CuCoNiBe). In this research, K type thermocouples were placed into the mold in such a way that there was a distance of 3 mm to the casting surface, and temperature changes during the production were achieved by the measurement and recording device. 1283,1263,1243,1223,1203,1183,1163 K values of casting temperatures that were identified as critical in Ansys Fluent program and interfacial heat transfer coefficient of the combinations created by casting temperatures of 413,473,533,593,653 K were calculated numerically. Casting simulation was created in Magma program by using calculated IHTC values, and they were analysed by making a comparison between experimental and simulation temperature curves. The match of the defects was controlled by comparing the defect results of simulation in which convergence within temperature curves were provided and the defects of scrap parts in experimental production.Keywords : Casting Defects, Casting Simulation, CFD, Copper-Beryllium Alloy, Interface Heat Transfer Coefficient (IHTC), Low Pressure Die Casting, Porosity Analysis